The alleged âwet wallâ of your tub surround is not really as easy to tile as the dry partitions that do not include water-supply pipes. You require to program a way to to operate up your tiles to the shower supply pipe, the valve that controls water temperature as well as the tub provide pipe — all which split the aircraft of the tiled wall that is damp. A cautious layout where tiles drop on the damp wall, marking helps you figure out the strategy of attack because of this project.
Mark a line on the wall that is damp to fall into line using the line between the second and first program of flooring tiles adjoining the tub apron. Extend the line using a 48-inch spirit-level before the line reaches 6 feet from the ground, held plumb. Mark a line at this 6-foot level with all the spirit-level held.
Create a cardboard template of the damp wall mixing valve areas and noting the offer pipes. Cut cement backer board panels to to match the region that is marked, using the edges avoiding having four corners meeting and based on studs, by snapping them and scoring the panels. Transfer the marks that are template to the cement backer board using a marker. Cut the pipe openings with a jig-saw or hole saws.
Screw the backer board. Apply thin set mortar to the seams using a trowel that is flat, press fiber glass tape to the mastic, and leading with a different layer of mortar. Allow to dry for 24 hrs.
Mark a line on the damp wall level with all the mid-point line utilized on the tub wall that was adjacent. Mark a vertical line in the mid-point of the moist wallâs backer board.
Tile mastic in one quadrant in a time using a V-notched trowel. Set your tile and carry on laying programs that were complete and vertically. Press plastic spacers between the tiles if they donât have integrated spacing nubs. Tile each quadrant in change, surrounding the fixture location with tiles that are uncut.
Mark the corners of tiles to to suit across the fixture pipes. In the event the pipes drop near where four tile corners or two tile edges satisfy snip off the un-needed tile materials with tile nippers. Smooth the edge with 80-grit sandpaper.
In the event the fixture pipes protrude at the center of a complete tile drill a hole in a tile. Hammer a beginning mark for the hole to the tile glaze. Roll a ring of plumberâs putty round the marked hole, press it down as well as the tile and add water to the ring. Drill the hole by having an carbide bit.
Apply mastic to the cement backer board and press tile in position or the cut.