Fiberglass wall liners are used with a tub or shower pan. The wall liners are watertight, and they work as the surround at the tub or shower when installed correctly. Liners are designed to work with their brand of tub or shower, but many permit you to modify the liner to fit your existing tub or shower. It is essential that you use cement planks in your walls as a substrate to prevent mold growth. Your cement planks ought to be level and straight for the best installation results that are liner.
Gauge the width of your wall. Place the wall liner onto a floor. Assess the diameter of the liner. The liner should be the exact same length or more than you want. It is unlikely your wall corners are straight. Place the liner on the wall as as possible with the liner level and also with the surface of the bathtub or skillet if they’re crooked. Place a compass together with the metal tip against the wall and the pencil onto the liner. Find the widest gap and open the compass to that width. Proceed the end of the compass along the wall with all the compass hauled away from the wall in a 90-degree angle. Scribe the wall edge onto the liner.
Cut with a rotary tool across the line that is scribed. Fit back the liner on the wall and to the corner. Mark the height of the liner onto the wall. Lay the liner back on the floor. Measure from the surface of the bathtub or shower pan to your mark. Transfer your measurement. Assess the width in your mark height and transfer your measurement. Assess the width and transfer that mark.
Check to find out how crooked your second corner is. When it’s every bit as jagged, notice the total amount of the location that is very crooked. Quantify that amount. Insert that measurement to the width of your liner on top and bottom marks. Use a straightedge to draw a line and cut on the fiberglass. Position the liner at the corner and scribe the correct fit. Cut your liner again. It should fit comfy and level. It become tight or ought not bind on the wall.
Apply construction adhesive on the wall. Use an adhesive. Position your liner and press it in the adhesive. Pull away the liner after a few seconds. Wait a moment and then press on the liner back . This will activate the adhesive and make it stick immediately.
Draw a vertical line in the facing edge of your bathtub or shower pan up the wall to the height of the liner. Repeat on each side. Measure to a line from the corner. In case your corner is crooked, utilize your scribing method to add the amount of the crookedness. Cut, recut and scribe. Your edge should stay level and vertical. Glue, lift and press on the panel.
Cut your faucet wall liner to dimension using the techniques. Quantify for the holes for the faucet head and taps and transfer those measurements to the liner. Check your measurements. Cut through the liner in your measurement saws. Glue, lift and press on the panel.
Fit the corner to the rear and side wall. Mark the edges of the corner onto the fiberglass in pencil. Apply glue within the marks to the fiberglass. Remove the paper backing on the adhesive strips built into the corner pieces. Press, press on and lift the corner. Repeat with the second corner. Allow the paste.